From: Rich Collins (nilsi2002@gmail.com)
Date: Thu Oct 30 2008 - 15:16:06 ARST
Hi Li,
So where are the tunnel interfaces configured? On those routers where they
are configured - what does "show mpls traffic-eng tunnels"show?
-Rich
On Fri, Oct 24, 2008 at 3:44 PM, <yungli2008@gmail.com> wrote:
> Hi experts,
>
> I am working with MPLS TE
>
> R1 Fa0/0 and R2 fa0/0 connected via switch
>
> Bit configuration below
> R1
> !
> interface FastEthernet0/0
> ip address 151.1.12.1 255.255.255.0
> duplex full
> mpls label protocol ldp
> mpls ip
> mpls traffic-eng tunnels
> ip rsvp bandwidth
>
> R2
> !
> interface FastEthernet0/0
> ip address 151.1.12.2 255.255.255.0
> duplex full
> mpls label protocol ldp
> mpls ip
> mpls traffic-eng tunnels
> ip rsvp bandwidth
>
> The IGP and BGP are fully reachable in my POD. seems everything is fine
> MPLS are working fine
> I enabled ( mpls traffic-eng router-id Loopback0, mpls traffic-eng area 0
> )
> under ospf process.
> I enabled" mpls traffic-eng tunnels" in global and interface mode
>
> my problem is
> Rack1R2#show ip rsvp neighbor
>
> Rack1R2#
> ( it showing nothing but mpls properly working in my POD I mean no problems
> in
> MPLS)
>
> Can anyone help me?
>
> I am using following IOS
> (C7200-ADVENTERPRISEK9-M), Version 12.4(15)T5, RELEASE SOFTWARE (fc4)
> (C3725-ADVIPSERVICESK9-M), Version 12.4(21), RELEASE SOFTWARE (fc1)
> (C3640-JK9O3S-M), Version 12.4(16), RELEASE SOFTWARE (fc1)
>
> I am facing this problem in dynamip
>
> Regards
> Li
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:23 ARST