IP RSVP

From: yungli2008@gmail.com
Date: Fri Oct 24 2008 - 17:44:43 ARST

• Next message: Michael Dorion: "Re: Frame-Relay QOS Question, please explain"
• Previous message: Reza Toghraee: "RE: Frame-Relay QOS Question, please explain"
• Next in thread: Rich Collins: "Re: IP RSVP"
• Maybe reply: Rich Collins: "Re: IP RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi experts,

I am working with MPLS TE

R1 Fa0/0 and R2 fa0/0 connected via switch

Bit configuration below
R1
!
interface FastEthernet0/0
 ip address 151.1.12.1 255.255.255.0
duplex full
 mpls label protocol ldp
 mpls ip
 mpls traffic-eng tunnels
  ip rsvp bandwidth
 
R2
!
interface FastEthernet0/0
 ip address 151.1.12.2 255.255.255.0
duplex full
 mpls label protocol ldp
 mpls ip
 mpls traffic-eng tunnels
ip rsvp bandwidth

The IGP and BGP are fully reachable in my POD. seems everything is fine
MPLS are working fine
I enabled ( mpls traffic-eng router-id Loopback0, mpls traffic-eng area 0 )
under ospf process.
I enabled" mpls traffic-eng tunnels" in global and interface mode

my problem is
Rack1R2#show ip rsvp neighbor

Rack1R2#
( it showing nothing but mpls properly working in my POD I mean no problems in
MPLS)

Can anyone help me?

I am using following IOS
(C7200-ADVENTERPRISEK9-M), Version 12.4(15)T5, RELEASE SOFTWARE (fc4)
(C3725-ADVIPSERVICESK9-M), Version 12.4(21), RELEASE SOFTWARE (fc1)
(C3640-JK9O3S-M), Version 12.4(16), RELEASE SOFTWARE (fc1)

I am facing this problem in dynamip

Regards
Li

Blogs and organic groups at http://www.ccie.net

• Next message: Michael Dorion: "Re: Frame-Relay QOS Question, please explain"
• Previous message: Reza Toghraee: "RE: Frame-Relay QOS Question, please explain"
• Next in thread: Rich Collins: "Re: IP RSVP"
• Maybe reply: Rich Collins: "Re: IP RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:22 ARST