From: John (jgarrison1@austin.rr.com)
Date: Thu Oct 23 2008 - 16:14:03 ARST
Is it a macro for interface range, or interface level commands?
I would think if you tried to apply it to all ports with interface range.
You would get an error message saying fx/x not a switchport.. Just apply to
all the ports that are in switch mode.
----- Original Message -----
From: "nouman abbasi" <abbasi.nouman@gmail.com>
To: "Cisco certification" <ccielab@groupstudy.com>
Sent: Thursday, October 23, 2008 11:18 AM
Subject: DTP Traffic
> Hi,
>
> My task for a question is to disable all DTP Traffic on all fast Ethernet
> port of a switch and couple of ports on the switch are pre-configured as
> no
> switchport. ( DTP traffic is disabled using Macro )
>
>
> If similiar question arises in the lab should the initial config part i.e
> no
> switchport can be removed and re-applied.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:22 ARST