From: GAURAV MADAN (gauravmadan1177@gmail.com)
Date: Wed Sep 24 2008 - 14:56:10 ART
I dont get any such warning ..
SW1(config)#do sh etherchannel load
EtherChannel Load-Balancing Configuration:
dst-mac
EtherChannel Load-Balancing Addresses Used Per-Protocol:
Non-IP: Destination MAC address
IPv4: Destination MAC address
IPv6: Destination MAC address
SW1(config)#
SW1(config)#port-c load dst-ip
SW1(config)#do sh etherchannel load
EtherChannel Load-Balancing Configuration:
dst-ip
EtherChannel Load-Balancing Addresses Used Per-Protocol:
Non-IP: Destination MAC address
IPv4: Destination IP address
IPv6: Destination IP address
May be some issue in IOS version you are using .
Gaurav Madan
On Wed, Sep 24, 2008 at 11:17 PM, KS Anpu <ksanpu@gmail.com> wrote:
> When i am configuring the load balancing method in a port channel , i am
> getiing this Warning: message but configuration is changed .... is it
> default behavior ?
>
> *SW2(config)#port-channel load-balance dst-mac
> Warning: Delete and re-create existing port channels to apply new load
> balance method to them
>
> SW2(config)#do sho ether load
> Po2 ---> Source XOR Destination IP address*
>
>
> Regards,
> Anbu
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:19 ART