From: KS Anpu (ksanpu@gmail.com)
Date: Wed Sep 24 2008 - 15:14:40 ART
It is in Dynamips. and IOS is c3640-jk9o3s-mz.123-14.T7.bin
Regards,
Anbu
On Wed, Sep 24, 2008 at 11:26 PM, GAURAV MADAN <gauravmadan1177@gmail.com>wrote:
> I dont get any such warning ..
>
> SW1(config)#do sh etherchannel load
> EtherChannel Load-Balancing Configuration:
> dst-mac
>
> EtherChannel Load-Balancing Addresses Used Per-Protocol:
> Non-IP: Destination MAC address
> IPv4: Destination MAC address
> IPv6: Destination MAC address
>
> SW1(config)#
> SW1(config)#port-c load dst-ip
> SW1(config)#do sh etherchannel load
> EtherChannel Load-Balancing Configuration:
> dst-ip
>
> EtherChannel Load-Balancing Addresses Used Per-Protocol:
> Non-IP: Destination MAC address
> IPv4: Destination IP address
> IPv6: Destination IP address
>
>
> May be some issue in IOS version you are using .
>
> Gaurav Madan
>
> On Wed, Sep 24, 2008 at 11:17 PM, KS Anpu <ksanpu@gmail.com> wrote:
> > When i am configuring the load balancing method in a port channel , i am
> > getiing this Warning: message but configuration is changed .... is it
> > default behavior ?
> >
> > *SW2(config)#port-channel load-balance dst-mac
> > Warning: Delete and re-create existing port channels to apply new load
> > balance method to them
> >
> > SW2(config)#do sho ether load
> > Po2 ---> Source XOR Destination IP address*
> >
> >
> > Regards,
> > Anbu
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:19 ART