From: backbone systems (backbone.systems@gmail.com)
Date: Thu Sep 04 2008 - 03:46:02 ART
I am using dynamips ... i will try to use a different IOS...
On Thu, Sep 4, 2008 at 9:45 AM, backbone systems
<backbone.systems@gmail.com> wrote:
> hmm.Thanks for the inputs.
>
> On Wed, Sep 3, 2008 at 9:09 PM, dara tomar <wish2ie@gmail.com> wrote:
>> I agree with Antonio,
>>
>> It's quite usual that some of the IOS are able to while the others aren't
>> able to make the desired markings.
>> The logic used to achieve will be correct, but still they don't :| .
>>
>> Change the IOS and make your observations again, in case you are confident
>> that there is no mistake from your side.
>>
>> Thanks,
>> Dara
>>
>>
>>
>> On Wed, Sep 3, 2008 at 10:04 PM, Antonio Soares <amsoares@netcabo.pt> wrote:
>>>
>>> It should work. I've loaded you config and i get the desired output:
>>>
>>> ++++++++++++++++++++++++++
>>> P2#sh policy-map interface
>>> Serial1/0
>>>
>>> Service-policy input: EXP5
>>>
>>> Class-map: EXP5 (match-all)
>>> 10 packets, 1120 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: mpls experimental topmost 5
>>> QoS Set
>>> qos-group 5
>>> Packets marked 10
>>>
>>> Class-map: class-default (match-any)
>>> 594 packets, 41199 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: any
>>> Serial1/1
>>>
>>> Service-policy output: MPtoMP
>>>
>>> Class-map: MPtoMP (match-all)
>>> 10 packets, 1120 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: qos-group 5
>>> QoS Set
>>> mpls experimental topmost 5
>>> Packets marked 10
>>>
>>> Class-map: class-default (match-any)
>>> 770 packets, 52869 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: any
>>> P2#
>>> ++++++++++++++++++++++++++
>>>
>>> Which IOS release and platform are you using ?
>>>
>>>
>>>
>>> Regards,
>>>
>>> Antonio Soares, CCIE #18473 (R&S)
>>> amsoares@netcabo.pt
>>>
>>> -----Original Message-----
>>> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
>>> backbone systems
>>> Sent: quarta-feira, 3 de Setembro de 2008 12:57
>>> To: Cisco certification
>>> Cc: SP Ccie
>>> Subject: MPLS QOS P Router Issue
>>>
>>> Hi,
>>>
>>> Below is the config from my P routers. On the Ingress i am marking the
>>> traffic to qos-group 5
>>> and on the Egress seting the mpls qos topmost to 5
>>>
>>> All the marking is done for telnet traffic .
>>>
>>> When i do the show policy-map on the ingress interface i can see the
>>> the traffic marked,
>>> R3#sh policy-map int ser2/2
>>> Serial2/2
>>>
>>> Service-policy input: EXP5
>>>
>>> Class-map: EXP5 (match-all)
>>> 86 packets, 4586 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: mpls experimental topmost 5
>>> QoS Set
>>> qos-group 5
>>> Packets marked 86
>>>
>>> Class-map: class-default (match-any)
>>> 815 packets, 56475 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: any
>>>
>>> But when i try to see my Egress interface , it is not setting the MPLS
>>> EXP bit to 5
>>>
>>> R3#sh policy-map int ser2/1
>>> Serial2/1
>>>
>>> Service-policy output: MPtoMP
>>>
>>> Class-map: MPtoMP (match-all)
>>> 0 packets, 0 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: qos-group 5
>>> QoS Set
>>> mpls experimental topmost 5
>>> Packets marked 0
>>>
>>> Class-map: class-default (match-any)
>>> 74 packets, 3978 bytes
>>> 5 minute offered rate 0 bps, drop rate 0 bps
>>> Match: any
>>>
>>> Below is the config of my router,
>>>
>>> R3#sh run
>>> Building configuration...
>>>
>>> Current configuration : 1948 bytes
>>> !
>>> upgrade fpd auto
>>> version 12.4
>>> service timestamps debug datetime msec
>>> service timestamps log datetime msec
>>> no service password-encryption
>>> !
>>> hostname R3
>>> !
>>> boot-start-marker
>>> boot-end-marker
>>> !
>>> logging message-counter syslog
>>> !
>>> no aaa new-model
>>> ip source-route
>>> ip cef
>>> !
>>> !
>>> !
>>> !
>>> no ipv6 cef
>>> !
>>> multilink bundle-name authenticated
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> archive
>>> log config
>>> hidekeys
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> class-map match-all MPtoMP
>>> match qos-group 5
>>> class-map match-all EXP5
>>> match mpls experimental topmost 5
>>> !
>>> !
>>> policy-map MPtoMP
>>> class MPtoMP
>>> set mpls experimental topmost 5
>>> policy-map EXP5
>>> class EXP5
>>> set qos-group 5
>>> !
>>> !
>>> !
>>> !
>>> !
>>> interface Loopback0
>>> ip address 3.3.3.3 255.255.255.255
>>> !
>>> interface FastEthernet0/0
>>> no ip address
>>> shutdown
>>> duplex half
>>> !
>>> interface Serial2/0
>>> no ip address
>>> encapsulation frame-relay
>>> serial restart-delay 0
>>> !
>>> interface Serial2/0.2 point-to-point
>>> ip address 20.0.0.3 255.0.0.0
>>> snmp trap link-status
>>> mpls ip
>>> frame-relay interface-dlci 302
>>> !
>>> interface Serial2/1
>>> ip address 14.0.0.3 255.0.0.0
>>> mpls ip
>>> serial restart-delay 0
>>> service-policy output MPtoMP
>>> !
>>> interface Serial2/2
>>> ip address 13.0.0.3 255.0.0.0
>>> mpls ip
>>> serial restart-delay 0
>>> service-policy input EXP5
>>> !
>>> interface Serial2/3
>>> no ip address
>>> shutdown
>>> serial restart-delay 0
>>> !
>>> interface ATM3/0
>>> no ip address
>>> shutdown
>>> no atm ilmi-keepalive
>>> !
>>> interface Serial4/0
>>> no ip address
>>> shutdown
>>> serial restart-delay 0
>>> !
>>> interface Serial4/1
>>> no ip address
>>> shutdown
>>> serial restart-delay 0
>>> !
>>> interface Serial4/2
>>> no ip address
>>> shutdown
>>> serial restart-delay 0
>>> !
>>> interface Serial4/3
>>> no ip address
>>> shutdown
>>> serial restart-delay 0
>>> !
>>> router ospf 1
>>> log-adjacency-changes
>>> network 0.0.0.0 255.255.255.255 area 0
>>> !
>>> ip forward-protocol nd
>>> no ip http server
>>> no ip http secure-server
>>> !
>>> !
>>> !
>>> logging alarm informational
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> control-plane
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> !
>>> gatekeeper
>>> shutdown
>>> !
>>> !
>>> line con 0
>>> stopbits 1
>>> line aux 0
>>> stopbits 1
>>> line vty 0 4
>>> login
>>> !
>>> end
>>>
>>>
>>> i seems i am doing some basic mistake!!!! Can someone identify that????
>>>
>>> BB
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:17 ART