From: Igor M. (imanassypov@rogers.com)
Date: Fri Aug 22 2008 - 11:21:28 ART
Should not be an issue, here is my config from scratch:
R1#sh run | s TEST
policy-map TEST
class class-default
shape average 56000
interface FastEthernet0/0.1
encapsulation dot1Q 1 native
ip address 10.1.1.1 255.255.255.0
service-policy output TEST
end
R1#sh policy-map interface f0/0.1
FastEthernet0/0.1
Service-policy output: TEST
Class-map: class-default (match-any)
1 packets, 352 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Traffic Shaping
Target/Average Byte Sustain Excess Interval Increment
Rate Limit bits/int bits/int (ms) (bytes)
56000/56000 1988 7952 7952 142 994
Adapt Queue Packets Bytes Packets Bytes Shaping
Active Depth Delayed Delayed Active
- 0 1 352 0 0 no
----------------------
I.M., M.Eng. P.Eng.
Network Architect
CI Investments
----------------------
--- On Fri, 8/22/08, GAURAV MADAN <gauravmadan1177@gmail.com> wrote:
From: GAURAV MADAN <gauravmadan1177@gmail.com>
Subject: Shaping : FE sub-int
To: "Cisco certification" <ccielab@groupstudy.com>
Received: Friday, August 22, 2008, 9:58 AM
hi all
i know this was discusse some time back ..... but asking again for
clearifications
I am confused regarding the application of serive policies at FE
sub-interfaces :
R2 R3
|------------------------| |--------------------------------|
R1
R1 f0/0.1 connects tp R2
R1 f0/0.2 connects to R3
Simple requirement : Send not more than 1 Mbps to R2 and not more than
2 Mbps to R3
policy-map R2
class class-default
shape average 1000000
!
int f0/0.1
service-pol out R2
Class Based Weighted Fair Queueing will be applied only to the
Virtual-Access interfaces associated with an MLP bundle.
How to rectify this error ?
I already went through :
http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a00801
14326.shtml
But couldnt get much out of it .
Thnx
Gaurav Madan
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:31 ART