From: L Pham (ccie17030@gmail.com)
Date: Sat Jun 28 2008 - 18:33:20 ART
Since all CRC and RUNT are directly related to L1 , ya may want to
match the Cat6 cable just to be sure ... Hard code the speed/duplex
will save you alot of headache.
I am guessing it part of the MD9xxx series ?
HTH,
Loc
On Sat, Jun 28, 2008 at 1:15 AM, vineesh viswanath
<vineesh_viswanath@hotmail.com> wrote:
> Hi all
>
> I am getting CRC error from the I/F connected to my SAN Box.
>
> Primary is connected to 6513 and Secondary on 4509 [DR site] , Sync is setup
> across the SAN Devices.
>
> SAN architect asked me to configure 100meg Full on both the site .
>
> SAN fabric is connected to the patch with a cat6 cable and from there to the
> 6513 a cat5e , will there be any issue due to this factor ?
> interface GigabitEthernet10/25 description Centera Server Primary switchport
> switchport access vlan 10 switchport mode access switchport nonegotiate no ip
> address speed 100 duplex full
>
> I have notices more runts and Giant packets on the i/f traffic
>
> Regards
>
> Vineesh
> _________________________________________________________________
>
> http://clk.atdmt.com/UKM/go/msnnkmgl0010000009ukm/direct/01/
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:23 ART