From: Larry (cc13lab@gmail.com)
Date: Mon Jun 16 2008 - 10:51:56 ART
I don't think VTP shows up in running unless you are in Transparent mode, at
least my switches don't:
Rack1SW2#show ver | in IOS
Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version
12.2(40)SE, RELEASE SOFTWARE (fc3)
Rack1SW2#
Rack1SW2#show run | in VTP
Rack1SW2#
On 6/16/08, ccie champ <ccie.champ@gmail.com> wrote:
>
> Is it about dynamips or real hardware?
>
> Typically these commands are there in sh run, if those are supported in
> configuration but you will not be able to see if switch just supoort vlan
> database.
>
>
>
>
> On 6/16/08, ccie <ccie@just-horizon.com> wrote:
> >
> > Hi Experts,
> >
> >
> >
> > How I could see the VTP command that I enter in the running, e.g.
> >
> > Vtp ver e
> >
> > Vtp domain Cisco
> >
> > They disappear in the running configuration? I want to copy and paste
> these
> > setting on the rest of the switches?
> >
> >
> >
> > Regards,
> >
> > Amin
> >
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:21 ART