From: Jason Madsen (madsen.jason@gmail.com)
Date: Mon Jun 16 2008 - 12:28:59 ART
show vtp status
show vtp pass
etc.
On Mon, Jun 16, 2008 at 7:51 AM, Larry <cc13lab@gmail.com> wrote:
> I don't think VTP shows up in running unless you are in Transparent mode,
> at
> least my switches don't:
>
> Rack1SW2#show ver | in IOS
> Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version
> 12.2(40)SE, RELEASE SOFTWARE (fc3)
> Rack1SW2#
>
> Rack1SW2#show run | in VTP
> Rack1SW2#
>
>
> On 6/16/08, ccie champ <ccie.champ@gmail.com> wrote:
> >
> > Is it about dynamips or real hardware?
> >
> > Typically these commands are there in sh run, if those are supported in
> > configuration but you will not be able to see if switch just supoort vlan
> > database.
> >
> >
> >
> >
> > On 6/16/08, ccie <ccie@just-horizon.com> wrote:
> > >
> > > Hi Experts,
> > >
> > >
> > >
> > > How I could see the VTP command that I enter in the running, e.g.
> > >
> > > Vtp ver e
> > >
> > > Vtp domain Cisco
> > >
> > > They disappear in the running configuration? I want to copy and paste
> > these
> > > setting on the rest of the switches?
> > >
> > >
> > >
> > > Regards,
> > >
> > > Amin
> > >
> > >
> > > _______________________________________________________________________
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:21 ART