From: Joseph Brunner (joe@affirmedsystems.com)
Date: Sat Jun 14 2008 - 22:26:54 ART
Brian: The boy has no patience
Me: Was I any different when you taught me
I learned along time ago not to doubt IE's racks... I 40+ rentals there
might have been one bad wic card or something, but no topology issues...
I am beginning to think Brian cables all the racks personally ;)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Dane
Newman
Sent: Saturday, June 14, 2008 7:53 PM
To: bdennis@internetworkexpert.com
Cc: Cisco certification
Subject: Re: Issue with internetwork Expert Security racks
yeah thanks for find that and sorry for wasting your time ;(
I am riding the short bus
On Sat, Jun 14, 2008 at 7:51 PM, Brian Dennis <
bdennis@internetworkexpert.com> wrote:
> Dane,
> Your access VLAN was 113 but your VLAN interface is 133. Additionally
> your IP addressing was wrong for rack6.
>
> Brian Dennis, CCIEx5 #2210 (R&S/ISP-Dial/Security/SP/Voice)
> bdennis@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com <http://www.internetworkexpert.com/>
> Toll Free: 877-224-8987
> Direct: +1-775-544-1653 (Outside the US and Canada)
>
> >----- Original Message -----
> Subject: Issue with internetwork Expert Security racks
> Date: Sat, June 14, 2008 16:20
> From: "Dane Newman" <dane.newman@gmail.com>
>
> > Hello
> >
> > I have an issue with InternetworkExpert security racks. Can anyone spot
> an
> > issue with my config and why I can't find 204.12.1.254 (bb3). I keep
> going
> > back and forth with IE support and I have wasted tons of time on this
> issue
> > and there support told me it was a problem with my config which I don't
> see
> > how it could be?
> >
> > BB3 is supposed to be connected to switch 1 via there cabling diagram
> in
> > port fa0/24. When I do a show cdp neighbor I get the following output
> >
> > Rack6SW1#show cdp ne
> > Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
> > S - Switch, H - Host, I - IGMP, r - Repeater, P -
Phone
> > Device ID Local Intrfce Holdtme Capability
> > Platform Port ID
> > RM-H-SW1 Fas 0/20 161 T S
> > WS-C2924-XFas 0/13
> > RM-H-SW1 Fas 0/24 161 T S
> > WS-C2924-XFas 0/15
> >
> >
> > This output clearly shows its connected to another switch (which is fine
> as
> > long as I could get conectivity to my backbone 3 router). I created a
> vlan
> > interface for vlan 133 and gave it the ip 204.12.1.50 and pinged ASA2's
> > interface of 204.12.1.13 fine as seen in the output below but was unable
> to
> > ping 204.12.1.254 When I show arp it gives
> >
> > Internet 204.12.1.254 0 Incomplete ARPA
> >
> > I also just hard coded int fa0/20 to trunk to the unknown switch on all
> > vlan's to see if I could ping it still and was not able too
> >
> > Rack6SW1#show int trunk
> > Port Mode Encapsulation Status Native vlan
> > Fa0/20 on 802.1q trunking 1
> > Fa0/23 on isl trunking 1
> > Port Vlans allowed on trunk
> > Fa0/20 1-4094
> > Fa0/23 1-4094
> > Port Vlans allowed and active in management domain
> > Fa0/20 1,3-5,9,29,33,44,69,112-113,115,133,137-138,170,783
> > Fa0/23 1,3-5,9,29,33,44,69,112-113,115,133,137-138,170,783
> > Port Vlans in spanning tree forwarding state and not pruned
> > Fa0/20 1,3-5,9,29,33,44,69,112-113,115,133,137-138,170,783
> > Fa0/23 1,3-5,9,29,33,44,69,112-113,115,133,137-138,170,783
> >
> > Rack1SW1#ping 204.12.1.254
> > Type escape sequence to abort.
> > Sending 5, 100-byte ICMP Echos to 204.12.1.254, timeout is 2 seconds:
> > .....
> > Success rate is 0 percent (0/5)
> > Rack6SW1#show arp
> > Protocol Address Age (min) Hardware Addr Type Interface
> > Internet 132.1.137.7 - 000a.8a28.f000 ARPA Vlan137
> > Internet 132.1.170.7 - 000a.8a28.f000 ARPA Vlan170
> > Internet 132.1.170.1 60 000d.bd03.f9e0 ARPA Vlan170
> > Internet 204.12.1.254 0 Incomplete ARPA
> > Internet 132.1.137.113 111 001a.2ffc.8916 ARPA Vlan137
> > Internet 204.12.1.13 15 001a.2ffc.8917 ARPA Vlan133
> > Internet 132.1.137.213 42 001a.2ffc.8916 ARPA Vlan137
> > Internet 204.12.1.50 - 000a.8a28.f000 ARPA Vlan133
> > Rack6SW1#show run int vlan 133
> > Building configuration...
> > Current configuration : 63 bytes
> > !
> > interface Vlan133
> > ip address 204.12.1.50 255.255.255.0
> > end
> > Rack6SW1#ping 204.12.1.13
> > Type escape sequence to abort.
> > Sending 5, 100-byte ICMP Echos to 204.12.1.13, timeout is 2 seconds:
> > !!!!!
> > Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms
> > Rack6SW1#
> >
> >
> >
> >
> > Below is my full config of switch 1
> >
> > Rack1SW1#show run
> > Building configuration...
> > Current configuration : 3450 bytes
> > !
> > ! Last configuration change at 16:08:51 UTC Sat Jun 14 2008
> > ! NVRAM config last updated at 14:26:33 UTC Sat Jun 14 2008
> > !
> > version 12.2
> > no service pad
> > service timestamps debug uptime
> > service timestamps log uptime
> > no service password-encryption
> > !
> > hostname Rack1SW1
> > !
> > enable password cisco
> > !
> > no aaa new-model
> > ip subnet-zero
> > ip routing
> > !
> > no ip domain-lookup
> > !
> > !
> > !
> > no file verify auto
> > spanning-tree mode pvst
> > spanning-tree extend system-id
> > !
> > !
> > !
> > vlan internal allocation policy ascending
> > !
> > !
> > interface Loopback0
> > ip address 150.1.7.7 255.255.255.0
> > !
> > interface FastEthernet0/1
> > switchport access vlan 170
> > switchport mode access
> > !
> > interface FastEthernet0/2
> > switchport access vlan 29
> > switchport mode access
> > !
> > interface FastEthernet0/3
> > switchport access vlan 3
> > switchport mode access
> > !
> > interface FastEthernet0/4
> > switchport access vlan 4
> > switchport mode access
> > !
> > interface FastEthernet0/5
> > switchport access vlan 115
> > switchport mode access
> > !
> > interface FastEthernet0/6
> > switchport access vlan 69
> > switchport mode access
> > !
> > interface FastEthernet0/7
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/8
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/9
> > switchport access vlan 29
> > switchport mode access
> > !
> > interface FastEthernet0/10
> > switchport access vlan 170
> > switchport mode access
> > !
> > interface FastEthernet0/11
> > switchport access vlan 112
> > switchport mode access
> > !
> > interface FastEthernet0/12
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/13
> > switchport access vlan 9
> > switchport mode access
> > !
> > interface FastEthernet0/14
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/15
> > switchport access vlan 133
> > switchport mode access
> > !
> > interface FastEthernet0/16
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/17
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/18
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/19
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/20
> > switchport trunk encapsulation dot1q
> > switchport mode trunk
> > !
> > interface FastEthernet0/21
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/22
> > switchport mode dynamic desirable
> > !
> > interface FastEthernet0/23
> > switchport trunk encapsulation isl
> > switchport mode trunk
> > !
> > interface FastEthernet0/24
> > switchport access vlan 113
> > switchport mode access
> > !
> > interface GigabitEthernet0/1
> > switchport mode dynamic desirable
> > !
> > interface GigabitEthernet0/2
> > switchport mode dynamic desirable
> > !
> > interface Vlan1
> > no ip address
> > shutdown
> > !
> > interface Vlan133
> > ip address 204.12.1.50 255.255.255.0
> > !
> > interface Vlan137
> > ip address 132.1.137.7 255.255.255.0
> > !
> > interface Vlan170
> > ip address 132.1.170.7 255.255.255.0
> > !
> > router ospf 1
> > router-id 150.1.7.7
> > log-adjacency-changes
> > redistribute connected subnets
> > redistribute static subnets
> > network 132.1.170.7 0.0.0.0 area 170
> > network 150.1.7.7 0.0.0.0 area 170
> > !
> > router bgp 100
> > no synchronization
> > bgp router-id 150.1.7.7
> > bgp log-neighbor-changes
> > neighbor 150.1.2.2 remote-as 100
> > neighbor 150.1.2.2 update-source Loopback0
> > neighbor 204.12.1.254 remote-as 54
> > neighbor 204.12.1.254 ebgp-multihop 255
> > no auto-summary
> > !
> > ip classless
> > ip route 132.1.138.0 255.255.255.0 132.1.137.213
> > ip route 204.12.1.0 255.255.255.0 132.1.137.113
> > ip http server
> > ip http secure-server
> > !
> > !
> > !
> > !
> > !
> > control-plane
> > !
> > !
> > line con 0
> > exec-timeout 0 0
> > privilege level 15
> > logging synchronous
> > line vty 0 4
> > password cisco
> > login
> > line vty 5 15
> > password cisco
> > login
> > !
> > !
> > end
> >
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:21 ART