From: Huan Pham (Huan.Pham@peopletelecom.com.au)
Date: Wed Jun 04 2008 - 20:24:58 ART
Hi,
You need to enable mls qos globally on SW2 as well. Have you?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
CCIE3000
Sent: Thursday, 5 June 2008 5:16 AM
To: Cisco certification
Subject: Can somebody spot my mistake coz I can't see what's up
Hi Guys,
Doing some QOS on switches and I just can't get it to work, I think I've
crossed the T's and dotted the i's but it ain't working.
Setup
3560
3550
R1 fa0/0------fa0/1 SW1 fa0/13 -----TRUNK------ fa0/13 SW2
fa0/2-----------fa0/0 R2
R1
class default matching everything going out to SW and marking it as DSCP
EF
SW1
mls qos
int fa0/1
mls qos trust dscp
SW2
class-map match all MATCH_EF
match ip dscp ef
policy-map MARK_EF
class MATCH_EF
trust dscp
set dscp cs4
interface fa0/13
service-policy input MARK_EF
I've configure an acl on R2 to match ip any any for all dscp values. I'm
still seeing it as EF.
When I do a show policy-map int fa0/13 I see the correct policy-map but
I'm not seeing any packets on either the MATCH_EF class or the default
class.
Any ideas what I'm missing? I've configure the class-map first, then the
policy-map and then applied it to the interface so I don't think I've
caused problem with order of operation (if there was one), I've also
reloaded the switch, but still no joy.
I'd appreciate any input if you guys can.
Thanks,
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:20 ART