From: itsfortarget iwillgetit (itsfortarget@gmail.com)
Date: Tue Jun 03 2008 - 16:54:43 ART
HELLO,
When port security is configured on the switch ports that are connected to
the HSRP enabled routers, it causes a MAC violation, since you cannot have
the same secure MAC address on more than one interface. A security violation
occurs on a secure port in one of these situations:
-
The maximum number of secure MAC addresses is added to the address table,
and a station whose MAC address is not in the address table attempts to
access the interface.
-
An address that is learned or configured on one secure interface is seen
on another secure interface in the same VLAN.
By default, a port security violation causes the switch interface to become
error-disabled and to shutdown immediately, which blocks the HSRP status
messages between the routers.
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml#topic5
On Tue, Jun 3, 2008 at 8:59 AM, Mike Haddad <mike.haddad@hotmail.com> wrote:
> Hello,
>
> When the question says do not use the BIA address for HSRP. Isn't it the
> default behavior of HSRP?
>
> Thanks in advance,
> Regards,
>
> _________________________________________________________________
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jul 01 2008 - 06:23:20 ART