From: Shawn Zandi (szmetal@gmail.com)
Date: Thu May 29 2008 - 08:24:25 ART
enabled on Fiber ports. those are copper.
On Thu, May 29, 2008 at 3:09 PM, ccie <ccie@just-horizon.com> wrote:
> Hi experts,
>
>
>
> Once enabling UDLD on the global configuration mode Using
>
>
>
> SW2(config)#udld enable
>
>
>
> According to my knowledge it should be enabled on all interface, but it
> show
> that it hasn't been enabled on any!!!
>
>
>
> Interface Fa0/1
>
> ---
>
> Port enable administrative configuration setting: Disabled
>
> Port enable operational state: Disabled
>
> Current bidirectional state: Unknown
>
>
>
> Interface Fa0/2
>
> ---
>
> Port enable administrative configuration setting: Disabled
>
> Port enable operational state: Disabled
>
> Current bidirectional state: Unknown
>
>
>
> Interface Fa0/3
>
> ---
>
> Port enable administrative configuration setting: Disabled
>
> Port enable operational state: Disabled
>
> Current bidirectional state: Unknown
>
>
>
> Any advice about that?
>
>
>
> Regards,
>
> Amin
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
-- Shafagh Zandi, www.shafagh.com
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART