From: Rehan Ali Waqas (rehanaliwaqas@hotmail.com)
Date: Tue May 27 2008 - 02:31:00 ART
Normally this problem arise when you add a space in key string, which does
not show up in Running Config.
Remove and Recreate key chain and beaware of key string without a space.
Regards,
RAW
> From: rik@guyler.net
> To: ccielab@groupstudy.com
> Subject: RIP MD5 follies
> Date: Mon, 26 May 2008 19:47:23 -0400
>
> I know I'm not the only one that despises MD5 authentication. Seems like
> there aren't too many other things in IOS-land that are as unpredictable
> when it comes to doing what it is supposed to be doing.
>
> I have SW2 and BB2 from an IE lab that are supposed to exchange RIP routes
> using MD5 authentication. I've reloaded both devices, verified the configs
> (yes, I cheated and looked at BB2 ;-) on both but the debugs on both sides
> continuously complain about the auth. I even checked the solution guide
and
> my config is identical except the name of the key chain name.
>
> key chain RIP
> key 1
> key-string CISCO
>
> interface Vlan82
> ip address 192.10.1.8 255.255.255.0
> ip rip authentication mode md5
> ip rip authentication key-chain RIP
>
> Anybody out there have a good method for clearing this type of mess up?
>
> --
> Rik
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART