From: lei tian (again.tl@gmail.com)
Date: Mon May 19 2008 - 23:24:46 ART
reflector-port will be any unused interface. What it does just copy your
monitored vlan traffic and then forward it.
On Mon, May 19, 2008 at 10:17 PM, <atlantaccie@gmail.com> wrote:
> I am working on this lab where SW1 and SW2 are connected via FA0/13 on both
> sides. Its a basic trunk config
>
> R1 fa0/0 is connected to fa0/1 on SW1
>
> R3 e0/0 is connected to fa0/3 on SW1
>
> R6 fa0/0 is connected to fa0/6 on SW2
>
> sw1#monitor session 1 source vlan 13 rx
> sw1#monitor session 1 destination remote vlan 100 reflector-port INTERFACE
> (What will go here)
>
> According to DOCCD
>
> For interface, specify the interface that will flood the RSPAN traffic onto
> the
> RSPAN VLAN. so in my case, will it be fa0/0 of R6? But when I try to ? @
> SW1
> after reflector-port, it gives me option to put fastethernet0/1-24 or
> g0/0-0/1.
> I am kind of confused. Any help would be highly appreciated.
>
> Thank you!
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:17 ART