From: David Prall (dcp@dcptech.com)
Date: Tue May 13 2008 - 18:52:41 ART
Same thing. Some versions of code accept "mpls ip" but put "tag-switching
ip". Some versions of code accept "tag-switching ip" but put "mpls ip". It
is just present to support upgrades and legacy configuration scripting.
David
-- http://dcp.dcptech.com> -----Original Message----- > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > Behalf Of marc fernandez > Sent: Tuesday, May 13, 2008 5:35 PM > To: ccielab@groupstudy.com > Subject: MPLS command on the interface (mpls ip) (tag ip) ? > > Question: if I am configuring mpls label ranges, protocol > either ldp tdp. > What is the difference on the interface command if it > supports (mpls ip ) > or (tag ip)? Is there a major difference? If so can you share some > experience or links on the subject? I've run into situations where the > router only supports one of the commands and not both. > > example: > > mpls label protocol ldp > mpls label range 20 40 > mpls ldp router-id loopback0 > > int f0/0.99 > mpls ip > > or > > int f0/0.99 > tag ip > > > ______________________________________________________________ > _________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART