MPLS command on the interface (mpls ip) (tag ip) ?

From: marc fernandez (mag08036@yahoo.com)
Date: Tue May 13 2008 - 18:35:25 ART

• Next message: Narbik Kocharians: "Re: Networkers 2008"
• Previous message: Mike M: "Re: ospf stub & NSSA"
• Next in thread: David Prall: "RE: MPLS command on the interface (mpls ip) (tag ip) ?"
• Maybe reply: David Prall: "RE: MPLS command on the interface (mpls ip) (tag ip) ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Question: if I am configuring mpls label ranges, protocol either ldp tdp.
What is the difference on the interface command if it supports (mpls ip )
or (tag ip)? Is there a major difference? If so can you share some
experience or links on the subject? I've run into situations where the
router only supports one of the commands and not both.

example:

mpls label protocol ldp
mpls label range 20 40
mpls ldp router-id loopback0

int f0/0.99
mpls ip

or

int f0/0.99
tag ip

• Next message: Narbik Kocharians: "Re: Networkers 2008"
• Previous message: Mike M: "Re: ospf stub & NSSA"
• Next in thread: David Prall: "RE: MPLS command on the interface (mpls ip) (tag ip) ?"
• Maybe reply: David Prall: "RE: MPLS command on the interface (mpls ip) (tag ip) ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART