From: V.Shekhar@GlobalAssurance.Net
Date: Sun May 11 2008 - 14:00:54 ART
I think it will be a good investment to buy some Rack time with any of
the noted vendors before your actual Exam to get a feel of real equipment.
---V Shekhar CCIE(sec)#17589/CISSP/RHCE.
KS Anpu wrote: > Hi , > I have tried to configure port channels in a dynamips lab setup and > then tried to configure destination mac based load -balancing over the > port-channel (used : port-channel load-balance dst-mac).At that time i got > the warning msg as > > *Warning: Delete and re-create existing port channels to apply new load > balance method to them*. > > then i checked , it is not changed from the default load balancing method. > > SW2#show etherchannel load-balance > Po2 ---> Source XOR Destination IP address > > So i am expecting your advise , if i will face the same question/issue in > the exam, is there any other way to solve > or do i want to delete and recreate the port-channel. > > Regards, > > Anbu. > > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART