From: KS Anpu (ksanpu@gmail.com)
Date: Sun May 11 2008 - 13:36:34 ART
Hi ,
I have tried to configure port channels in a dynamips lab setup and
then tried to configure destination mac based load -balancing over the
port-channel (used : port-channel load-balance dst-mac).At that time i got
the warning msg as
*Warning: Delete and re-create existing port channels to apply new load
balance method to them*.
then i checked , it is not changed from the default load balancing method.
SW2#show etherchannel load-balance
Po2 ---> Source XOR Destination IP address
So i am expecting your advise , if i will face the same question/issue in
the exam, is there any other way to solve
or do i want to delete and recreate the port-channel.
Regards,
Anbu.
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART