Policy Map

From: John (jgarrison1@austin.rr.com)
Date: Tue May 06 2008 - 16:07:30 ART

• Next message: Victor Cappuccio: "Re: Policy Map"
• Previous message: Lucy Favaloro: "Re: How to Become a CCIE v2"
• Next in thread: Victor Cappuccio: "Re: Policy Map"
• Maybe reply: Victor Cappuccio: "Re: Policy Map"
• Maybe reply: Sadiq Yakasai: "Re: Policy Map"
• Maybe reply: John: "Re: Policy Map"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I have the following configuration. When I initially configured this and did
a show policy-map s0/0/0 it showed that policy-map rtp was attatched to
s0/0/0. I modified the policy-map and then it "disappeared" as far as s0/0/0
was concerned. I deleted the mods to the policy-map unapplied the policy-map
and reapplied it. then I unapplied it again rebooted the router and reapplied
the policy-map to s0/0/0 still no joy.

R3(config)#DO SH POLICY-MAP
  Policy Map rtp
    Class rtp
      Strict Priority
      Bandwidth 25 (%)
R3(config)#DO SH RUN INT S0/0/0
Building configuration...

Current configuration : 346 bytes
!
interface Serial0/0/0
 ip address 191.1.34.3 255.255.255.0
 encapsulation frame-relay
 ip ospf authentication
 ip ospf authentication-key CISCO
 ip ospf network point-to-point
 frame-relay map ip 191.1.34.3 304
 frame-relay map ip 191.1.34.4 304 broadcast
 no frame-relay inverse-arp
 frame-relay lmi-type cisco
 service-policy output rtp
end

R3(config)#DO SH POLICY-MAP S0/0/0

R3(config)#

• Next message: Victor Cappuccio: "Re: Policy Map"
• Previous message: Lucy Favaloro: "Re: How to Become a CCIE v2"
• Next in thread: Victor Cappuccio: "Re: Policy Map"
• Maybe reply: Victor Cappuccio: "Re: Policy Map"
• Maybe reply: Sadiq Yakasai: "Re: Policy Map"
• Maybe reply: John: "Re: Policy Map"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:16 ART