From: Nikhil Engineer (ccienovice@gmail.com)
Date: Tue Apr 22 2008 - 15:09:50 ART
hi Shamin.
Pls check the engine the interface or the module is using. L2 engine does
not support QOS.
Pls verify.
Cheers,
Nikhil E.
On Tue, Apr 22, 2008 at 8:45 AM, Shamin <ccie.xpert@gmail.com> wrote:
> Dear All,
>
> I have a scenario in which I have a Cisco 7609 connecting to the WAN (i.e
> MPLS/VPN) using a dot1q Gigabit sub interfaces.
> Each of the Sub interfaces are in seperate VRF's representing different
> VPNs
> connecting to other sites.
>
> The requirement is that, in each of the sub interface I need to make sure
> that , the traffic does not exceed 10MB and in this 10MB
> I need to gurantee a minimum 2MB bandwidth for a particular stream of
> traffic.
>
> I tried to acheive this by using nested policy with Child policy using a
> Bandwidth command and the Parent policy Shaping all traffic
> to 10MB.
>
> But I found that, the 7609 does not support shaping. Then I tried using
> Policing in the Parent policy. It gave me an error that queing is not
> supported
> on this interface.
>
> Can anyone guide me on this. Anyone had faced a similar scenario?
>
> Regards
> Shameen
>
>
> Pass the CCIE in six weeks, Guaranteed!
> http://www.certscience.com/CCIE
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:51 ART