From: WorkerBee (ciscobee@gmail.com)
Date: Thu Mar 27 2008 - 06:32:54 ART
PFC only support a very limited MQC commands.
Probably you can trunk to Cisco router and perform policing from there.
Please read the following:
On Thu, Mar 27, 2008 at 5:07 PM, Hunt, Richard (LDN-GIS)
<Richard.Hunt@interpublic.com> wrote:
> Hi All,
> I'm trying to prioritize one particular IP subnet outbound through a
> Tunnel interface on a Cat 6500.
> I've tried MQC using nested policies (needed in IOS for Tunnel
> interfaces genrally) which generates this message "MQC features are not
> supported for this interface"
>
>
> Eg #1
> class-map match-all voice-budapest
> match access-group name voice-budapest
>
> policy-map voice-budapest
> class voice-budapest
> priority 2000000
> policy-map Tunnel-67
> class class-default
> shape average 8000000
> service-policy voice-budapest
>
>
> Extended IP access list voice-budapest
> 10 permit ip any 10.20.208.0 0.0.0.255
>
> 6500(config-if)#service-policy output Tunnel-67
> MQC features are not supported for this interface
>
>
>
>
> and I also tried simple priority queuing.
>
> However, this beast is proving difficult.
> Does anyone have any experience of how I could achieve this?, It (the
> 6500) is running a L3 image with a PFC2.
>
>
> This message contains information which may be confidential and privileged.
> Unless you are the intended recipient (or authorized to receive this message
> for the intended recipient), you may not use, copy, disseminate or disclose to
> anyone the message or any information contained in the message. If you have
> received the message in error, please advise the sender by reply e-mail, and
> delete the message. Thank you very much.
> (A)
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART