From: Noor.Yousuf@shell.com
Date: Wed Mar 26 2008 - 11:07:55 ART
Try this,
int g1/0/24
mls qos vlan-based
class-map interface
match input-interface g1/0/24
policy-map interface
class interface
policy-map prec
class any
set ip prec 5
service-policy interface
int vlan 50
no ip address
service-policy input prec
Thanks,
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Moses Polalysa
Sent: woensdag 26 maart 2008 14:44
To: Gabriel Nunes
Cc: ccielab@groupstudy.com
Subject: Re: Apply MQC in switchport
Hi,
Thanks for the reply. I have tried again but it also not working.
SW1(config-if)#exit
SW1(config)#int vlan 10
SW1(config-if)#service-policy output VLAN
Match input interface is not supported for this interface
SW1(config-if)#
Basically, I want to mark traffic from, let's say, VLAN 50 in Gi1/0/24 with ip precedence 5.
Regards,
Moses
----- Original Message ----
From: Gabriel Nunes <gabriel.nunes@gmail.com>
To: Moses Polalysa <mpurple7@yahoo.com>
Cc: ccielab@groupstudy.com
Sent: Wednesday, March 26, 2008 8:36:29 PM
Subject: Re: Apply MQC in switchport
the vlan-based command should be applied on layer 2 interface and service-policy on SVI interface
On Wed, Mar 26, 2008 at 10:26 AM, Moses Polalysa <mpurple7@yahoo.com> wrote:
Hi,
Thanks for your reply. I have tried but still not work out. :(
SW1(config-if)#mls qos vlan-based
SW1(config-if)#service-policy out VLAN_A
Match input interface is not supported for this interface
SW1(config-if)#
Regards,
Moses
----- Original Message ----
From: Gabriel Nunes <gabriel.nunes@gmail.com>
To: Sadiq Yakasai <sadiqtanko@gmail.com>
Cc: Moses Polalysa <mpurple7@yahoo.com>; ccielab@groupstudy.com
Sent: Wednesday, March 26, 2008 7:33:28 PM
Subject: Re: Apply MQC in switchport
I think you must configure "mls qos vlan-based" on switchport interface and so configure the service-policy on SVI interface.
Gabriel
On Wed, Mar 26, 2008 at 7:50 AM, Sadiq Yakasai <sadiqtanko@gmail.com> wrote:
Hi Moses,
Not all platforms support marking traffic in all directions actually.
And my guess is you are experiencing this behaviour on the 3560.
Try going through the documentation and seeing if egress marking is
supported on the 3560. Else, you could change your concept and mark on
the ingress anyway.
HTH
Sadiq
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART