From: Tim Curci (timcurci@roadrunner.com)
Date: Sun Feb 03 2008 - 00:35:13 ARST
I have two PIX-515Es that I have configured for Lan based failover. I do not
have the serial cable connected between them when I do "show failover" I get:
pix1# show failover
Failover On
Cable status: My side not connected
Failover unit Secondary
Failover LAN Interface: N/A - Serial-based failover enabled
Unit Poll frequency 15 seconds, holdtime 45 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 2 of 250 maximum
Version: Ours 8.0(2), Mate Unknown
Last Failover at: 21:53:04 UTC Feb 2 2008
This host: Secondary - Active
Active time: 870 (sec)
Interface outside (209.165.200.225): Link Down (Waiting)
Interface inside (192.168.10.1): Link Down (Waiting)
Other host: Primary - Not Detected
Active time: 0 (sec)
Interface outside (209.165.200.226): Unknown (Waiting)
Interface inside (192.168.10.2): Unknown (Waiting)
Stateful Failover Logical Update Statistics
Link : Unconfigured.
I do not want to use serial based failover and have no idea how to get rid of
this. Show I re-image the devices?
I have LAN based failover configured of both PIX devices.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2008 - 16:54:47 ARST