From: Satha Nantheesan (Nantheesan@enterprisetl.com)
Date: Tue Jan 29 2008 - 02:25:39 ARST
I have used the switch module in cisco 3640. My problem was when ever I
am re starting the dynamips vlan & vtp information (vlan.dat) file is
not there. So I want to configure vtp mode , vlans again.
I think you may using the new version of dynamips.Now it is ok by
putting the vtp file nvram:vlan.dat command in the configuration mode.
Regards,
Nantheesan.
-----Original Message-----
From: Peter [mailto:engpeter@gmail.com]
Sent: Tuesday, January 29, 2008 4:58 AM
To: Satha Nantheesan
Subject: RE: Dynamips VTP issue...vlan.dat file
Satha,
I'm using dynamips as well,,, and I'm able to emulate 3640s and 2600s.
But where do you use VTP configuration? Do you have switches in
Dynamips?
As far as I know, the dynamips is not able to emulate switching
platforms.
Cheers,
Peter
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Satha Nantheesan
Sent: Monday, January 28, 2008 07:29
To: ccielab@groupstudy.com
Cc: Satha Nantheesan
Subject: Dynamips VTP issue...vlan.dat file
Hi
I Have an issue in Dynamips when I am practicing, every thing ok .
But if I saved the configuration and closed the dynamips and open it
again ,all the configuration are there other than VTP configuration. So
I want to know is there any possibility to save the VTP info (vlan.dat
file) in Dynamips permanently.
Regards,
Nanthee.
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:38:02 ARST