From: Cielieska Nathan (ncielieska@gmail.com)
Date: Mon Jan 14 2008 - 20:10:39 ARST
http://www.cisco.com/en/US/tech/tk364/
technologies_configuration_example09186a00802135d3.shtml
PBR is configurable on both the 6500 and 3550. Those commands are the
cornerstone of PBR so they should be supported.
Regards,
Nate
On Jan 13, 2008, at 8:33 AM, Muhammad Saleem wrote:
> Can I run Set IP Default Next-Hop (IP add of Default Gateway) under a
> route-map on any Catalyst 6500 series of switch, or any other layer
> 3 switch
> supports this command? this command does not work on CAT3550 layer
> 3 and
> CAT3750 layer 3 switches, I want to make policy based routing in my
> VLAN
> environment like students VLAN should go through first default
> gateway and
> employees VLAN should go through second default gateway and all the
> servers
> VLAN should go through the third default gateway.
>
> The point using set IP default next-hop gateway is, this command first
> searches the locally available route to forward traffic if doesn't
> find the
> route then it sends it to default gateway.
>
> I will appreciate all the responses.
>
>
>
> Saleem
>
> ______________________________________________________________________
> _
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST