From: George Goglidze (goglidze@gmail.com)
Date: Wed Jan 09 2008 - 12:11:17 ARST
Hi Darby,
Thanks for your answer,
but as I already said in my post, "no ip bootp server" command does not
exist on the switch.
Regards,
On Jan 9, 2008 1:25 PM, Darby Weaver <darbyweaver@yahoo.com> wrote:
> Have you considered:
>
> no ip bootp server
>
> Bootstrap Protocol (BOOTP) services: To disable BOOTP
> services, use the no ip bootp server command in IOS
> global configuration mode. Using the no ip bootp
> server command by itself will not stop the router from
> listening on UDP port 67 because this "well-known"
> port is also used by DHCP, which is described later in
> this list. This command is widely available within
> IOS.
>
> So....
>
> no ip service dhcp might be needed as well.
>
> My rack is off at the moment...
>
> That should do it.
>
>
>
>
>
>
> --- George Goglidze <goglidze@gmail.com> wrote:
>
> > Hi all,
> >
> > Hi can I disable bootp service on a 3550 switch?
> >
> > SW1#sh ip sockets
> > Proto Remote Port Local Port In
> > Out Stat TTY OutputIF
> > 17 --listen-- --any-- 1975 0
> > 0 11 0
> > 17 0.0.0.0 0 1.1.1.1 2228 0
> > 0 211 0
> > 17 0.0.0.0 0 1.1.1.1 67 0
> > 0 2211 0
> >
> >
> > it shows that it's active.
> > but I have no command "no ip bootp service"
> > available.
> >
> > Thanks,
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:58 ARST