IPv6 tunneling

From: YourPal (dearprudence28@gmail.com)
Date: Mon Jan 07 2008 - 12:24:32 ARST

Next message: Cielieska Nathan: "Re: Invitation to connect on LinkedIn"
Previous message: Gary Duncanson: "Re: cciecert book ?!!"
Next in thread: Joseph Saad: "Re: IPv6 tunneling"
Maybe reply: Joseph Saad: "Re: IPv6 tunneling"
Maybe reply: Scott Vermillion: "RE: IPv6 tunneling"
Maybe reply: Narbik Kocharians: "Re: IPv6 tunneling"
Maybe reply: Narbik Kocharians: "Re: IPv6 tunneling"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,
For IPv6 tunneling, if asked to use an IPv4-based GRE tunnel, do I need to
configure the "tunnel mode ipv6ip" command?

E.g.
interface Tunnel0
no ip address
ipv6 address FEC0::2/64
tunnel source 150.1.2.2
tunnel destination 150.1.4.4
tunnel mode ipv6ip <--- Did I violate the task requirement with this
command?
!

I find that with/without that command works, i.e. both routers can ping each
other.

Please advise.

Thank you.

BR,
Emil

Next message: Cielieska Nathan: "Re: Invitation to connect on LinkedIn"
Previous message: Gary Duncanson: "Re: cciecert book ?!!"
Next in thread: Joseph Saad: "Re: IPv6 tunneling"
Maybe reply: Joseph Saad: "Re: IPv6 tunneling"
Maybe reply: Scott Vermillion: "RE: IPv6 tunneling"
Maybe reply: Narbik Kocharians: "Re: IPv6 tunneling"
Maybe reply: Narbik Kocharians: "Re: IPv6 tunneling"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:58 ARST