RE: Anyone know the 5 seconds average load MIB value to use it

From: Joseph Brunner (joe@affirmedsystems.com)
Date: Fri Jan 04 2008 - 13:08:33 ARST

• Next message: Bob Sinclair: "Re: ip pim dr-priority ?"
• Previous message: Joseph Brunner: "RE: 19711"
• Maybe in reply to: Joseph Brunner: "RE: Anyone know the 5 seconds average load MIB value to use it"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Perhaps you are looking for this?

rmon event 1 trap public description "Five Minute CPU Average Above 75%"
owner config

rmon event 2 trap public description "Five Minute CPU Average Below 40%"
owner config

rmon alarm 1 lsystem.58.0 60 absolute rising-threshold 75 1
falling-threshold 40 2 owner config

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of amin
Sent: Friday, January 04, 2008 6:46 AM
To: ccielab@groupstudy.com
Subject: Anyone know the 5 seconds average load MIB value to use it in the
RMON?

Dear Expert,

Anyone know the 5 seconds average load MIB value to use it in the RMON?

Regards,

Amin

• Next message: Bob Sinclair: "Re: ip pim dr-priority ?"
• Previous message: Joseph Brunner: "RE: 19711"
• Maybe in reply to: Joseph Brunner: "RE: Anyone know the 5 seconds average load MIB value to use it"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:57 ARST