From: Kim teu (kim.teu@gmail.com)
Date: Wed Dec 26 2007 - 11:04:47 ART
Do a show fram map to see ifyou have any unwanted mapping.
Regards,
Kim
On 12/26/07, Tom Hanks <t_hanks_2007@yahoo.com> wrote:
>
> Hi Guys,
>
> I am facing a problem in a topology where an OSPF area X is connecting R1
> and R2 to my 4 switches, and two of the 4 switches are also running OSPF
> Area Y. I am running a DOT1q-tunnel on two switches, hence am changing the
> MTU of all the the switches to 1504 since the 4 switches are meshed(system
> mtu 1504).
>
> However, I am facing a problem on one of the frame-relay point to point
> connections forming an adjacency in OSPF area X on R1 and R2. I have given
> the command "ip ospf mtu-ignore" on the relevant interfaces of R1 and R2
> that are connecting to the switches, however R1 and R2 adjacency over
> frame-relay serial main int gets stuck in INIT state, and when I run debug
> it says :
>
> "Mismatch Area X in the header"
>
> Any clues on this ?
>
> Regards
>
> Tom
>
>
>
> ____________________________________________________________________________________
> Never miss a thing. Make Yahoo your home page.
> http://www.yahoo.com/r/hs
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:32 ARST