From: Tom Hanks (t_hanks_2007@yahoo.com)
Date: Wed Dec 26 2007 - 05:59:50 ART
Hi Guys,
I am facing a problem in a topology where an OSPF area X is connecting R1 and R2 to my 4 switches, and two of the 4 switches are also running OSPF Area Y. I am running a DOT1q-tunnel on two switches, hence am changing the MTU of all the the switches to 1504 since the 4 switches are meshed(system mtu 1504).
However, I am facing a problem on one of the frame-relay point to point connections forming an adjacency in OSPF area X on R1 and R2. I have given the command "ip ospf mtu-ignore" on the relevant interfaces of R1 and R2 that are connecting to the switches, however R1 and R2 adjacency over frame-relay serial main int gets stuck in INIT state, and when I run debug it says :
"Mismatch Area X in the header"
Any clues on this ?
Regards
Tom
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:32 ARST