From: Rakesh Menon \(rakmenon\) (rakmenon@cisco.com)
Date: Thu Nov 29 2007 - 12:40:00 ART
I think I did this once, bringing the entire physical interface to
default configs can fix it too (if u cant reload).
Router(config)#default interface serial */*
Let me know if u try this, would help me remember too.
With Regards,
Rakesh Menon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Edison Ortiz
Sent: Thursday, November 29, 2007 8:50 PM
To: 'Envuladu Tsaku'; ccielab@groupstudy.com
Subject: RE: Deleting a serial subInterface
Reboot the router.
Edison Ortiz
Routing and Switching, CCIE # 17943
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Envuladu Tsaku
Sent: Thursday, November 29, 2007 9:20 AM
To: ccielab@groupstudy.com
Subject: Deleting a serial subInterface
Hi techs,
I was configuring point to poing subinterfaces for frame relay
multipoint
connection.I mistakingly configured #interface s0/1 p instead of
#interface
s0/1 mu.
now i cant change it back.if i change it back it gives me an error %
Warning: cannot change link type i tiried deletting the subinterface
but
it wont delete,gives me this error.
#no int s0/0.1 point-to-point
Not all config may be removed and may reappear after reactivating the
sub-interface
what do i do ?
---------------------------------
Never miss a thing. Make Yahoo your homepage.
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:32 ART