From: Eric Phillips (ephillips@squick.cc)
Date: Thu Nov 29 2007 - 12:22:22 ART
Envuladu,
You need to delete the sub interface, save your config, and reload. I do
not know of a way to force that config out without a reload.
You might want to configure soft reloads if you do this often. I much
prefer soft reloads for my lab becuase it saves a lot of time when you
reload often.
Hope that helps,
-Eric
On 11/29/07, Envuladu Tsaku <tenvuladu@yahoo.com> wrote:
>
> Hi techs,
>
> I was configuring point to poing subinterfaces for frame relay multipoint
> connection.I mistakingly configured
> #interface s0/1 p
> instead of
> #interface s0/1 mu.
>
> now i cant change it back.if i change it back it gives me an error
> % Warning: cannot change link type
> i tiried deletting the subinterface but it wont delete,gives me this
> error.
>
> #no int s0/0.1 point-to-point
> Not all config may be removed and may reappear after reactivating the
> sub-interface
>
>
> what do i do ?
>
>
>
>
>
>
> ---------------------------------
> Never miss a thing. Make Yahoo your homepage.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:32 ART