From: ccie ccie (cciefun@gmail.com)
Date: Wed Nov 28 2007 - 07:34:01 ART
Hi Tech Lover,
I dont have spoke to spoke mapping i only have HUB to Spoke mapping.
If i remove rip & put opsf with network type ip os net po to multi it works.
router rip
net 0.0.0.0
remove eith ospf as below
router os 1
network 0.0.0.0 0.0.0.0 ar 0 ( & network type ip os net point-to-mul )
its work fine. I can ping spoke to spoke & i learn all ospf routes.
If i map spoke to spoke it will work.
Question: (Note : HUB/SPOKE FR interface is main interface so by default
split hori is disable)
1. If i am learning network of one spoke on another spoke why i cant ping in
RIP case.
2. Do we need spoke to spoke mapping in RIP if yes why why???
Regards
Mike
On 11/28/07, Vaibhav Sharma <vaisharm@cisco.com> wrote:
>
> Do you have p2p subif on the spokes with the correct dlci specified? If
> you
> are using the main interface instead then you will have to have static
> mapping between the spokes via the hub.
>
> -vaibhav
>
> ----- Original Message -----
> From: "ccie ccie" <cciefun@gmail.com>
> To: "Cisco certification" <ccielab@groupstudy.com>
> Sent: Wednesday, November 28, 2007 2:58 PM
> Subject: RIP over FR (hub&spoke) not working properly..
>
>
> > Hi Tech Lover,
> >
> > (spoke ) R1 <=====-FR static map========> - R2 Hub <======FR static
> > map====> --R3.
> >
> > No static/dynamic map between sopkes. I am running RIP V2 i am getting
> > routes of R1 in R3 & vice versa but unable to ping R1 loopback
> >
> > RIP config as below
> >
> > router rip
> > network 0.0.0.0
> >
> > Regads
> > Mike
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART