From: Vaibhav Sharma (vaisharm@cisco.com)
Date: Wed Nov 28 2007 - 07:21:33 ART
Do you have p2p subif on the spokes with the correct dlci specified? If you
are using the main interface instead then you will have to have static
mapping between the spokes via the hub.
-vaibhav
----- Original Message -----
From: "ccie ccie" <cciefun@gmail.com>
To: "Cisco certification" <ccielab@groupstudy.com>
Sent: Wednesday, November 28, 2007 2:58 PM
Subject: RIP over FR (hub&spoke) not working properly..
> Hi Tech Lover,
>
> (spoke ) R1 <=====-FR static map========> - R2 Hub <======FR static
> map====> --R3.
>
> No static/dynamic map between sopkes. I am running RIP V2 i am getting
> routes of R1 in R3 & vice versa but unable to ping R1 loopback
>
> RIP config as below
>
> router rip
> network 0.0.0.0
>
> Regads
> Mike
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART