From: M_A_Jones@Dell.com
Date: Tue Nov 27 2007 - 15:30:39 ART
If you enable BPDU Guard on every interface, isnt that Global???
:)
Michael Jones
Network Engineer
Global Network Operations
Dell Inc. | Information Technology
W. 512.723.3268 | C. 512.966.6908
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mounir Mohamed
Sent: Tuesday, November 27, 2007 12:03 PM
To: Asim Zafar
Cc: Cisco certification
Subject: Re: bpdugaurd
Dear Asim,
BPDU can not be enabled globally, but you can enable BPDUGUARD with
portfast, in this case the command only effect all ports has portfast
enabled.
You can enable portfast per interface or globally by use
SW1(config)#spanning-tree portfast default
If you asked to enable BPDUGUARD on all access-ports you can do it with
the below tow commands
SW1(config)#spanning-tree portfast default SW1(config)#spanning-tree
portfast bpduguard default
You can verify it by:
SW1#show spanning-tree interface f0/1 detail | inc Bpdu|portfast
The port is in the portfast mode by default
Bpdu guard is enabled by default
Best Regards,
Mounir Mohamed
On Nov 27, 2007 2:03 PM, Asim Zafar <asim.mz@gmail.com> wrote:
> Hi Techs,
>
>
> If I implement BPDUGAURD on global config mode will it be implemented
> on all access ports or it will be implemented on all ports regardless
> access, trunk on the switch, if this is true then will we have to
> configure them separately on all ports.
>
>
> --
> Thanks & Regards,
>
> Asim Zafar
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Best Regards, Mounir Mohamed
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART