From: EDL (r.s.cciestudy@gmail.com)
Date: Mon Nov 26 2007 - 20:59:54 ART
Hi,
DCE side needs clock rate to be configured.
Ed
On 11/26/07, advitar84@yahoo.com <advitar84@yahoo.com> wrote:
> Took the statement ppp authen chap out of R5 config so it now reads
>
> interface Serial0/1
> ip address 132.1.45.5 255.255.255.0
> encapsulation ppp
> ppp chap hostname R5
> end
>
> Same issue remains though
>
> Im using a DCE/DTE cable to connect both there serial interfaces Its not
> like HDLC I don't need a clock rate right?
>
> Rack1R5(config-if)#do show controller s0/1
> Interface Serial0/1
> Hardware is Quicc 68360
> DTE V.35 clocks stopped.
> idb at 0x64200B30, driver data structure at 0x6420824C
> WIC interrupt reg = F
> SCC Registers:
>
> Interface Serial0/1
> Hardware is Quicc 68360
> DCE V.35, no clock
> idb at 0x6430E670, driver data structure at 0x64315D8C
> WIC interrupt reg = F
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART