From: Bob Sinclair (bob@bobsinclair.net)
Date: Sun Nov 25 2007 - 23:25:29 ART
Gregory Gombas wrote:
> Hello Experts,
>
> When configuring frame-relay bridging in a hub and spoke frame-relay
> setup, is it necessary to configure bridging on the spoke routers as
> well?
>
>
Yes, it is. Routed and bridged traffic over Frame-Relay uses different
encapsulation types. Packets bridged on Frame-Relay will have an
encapsulated Ethernet frame. Do some debug frame packet on both the
routed and bridged sides.
You can do a work around by putting an IP address on the bridged side
and doing a static arp. We go into this in our Frame-Relay CoD, if you
are interested.
Hth,
--Bob Sinclair CCIE 10427 CCSI 30427 www.netmasterclass.net
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART