From: slevin kremera (slevin.kremera@gmail.com)
Date: Fri Nov 23 2007 - 21:03:30 ART
i think udld global is only for fibre optics.for copper ports only
udld on interface shud suffice.THis is as per IEWB wb lab4 task 1.5
On Nov 24, 2007 4:44 AM, Tarun Pahuja <pahujat@gmail.com> wrote:
> Fawaz,
> Please do not forget to turn on UDLD globally first before
> configuring the specific port.
>
>
> http://cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_37_se/configuration/guide/swudld.html
>
> HTH,
> Tarun
>
>
> On 11/23/07, Fawaz Habeeb <fawazhabeeb@gmail.com> wrote:
> >
> > Dear all,
> >
> > I have a question, kindly requesting to solve this problem for me. I have
> > been seraching for an answer in cisco website..but no luck....
> >
> > My question is :
> >
> >
> > Scenario:
> >
> >
> >
> > I have two switches (SW1 and SW2) connected to each other by Fast-Ethernet
> > port ( i.e SW1 fa 0/23 to SW2 fa 0/23) and (SW1 fa0/24 to SW2 fa 0/24).
> >
> >
> >
> > I have configured port-channel between them.
> >
> >
> >
> > SW1
> >
> > Int ra fa 0/23-24
> >
> > Sw tr enc dot1
> >
> > Sw mode tr
> >
> > Channel-group 1 mode on
> >
> >
> >
> > SW2
> >
> > Int ra fa 0/23-24
> >
> > Sw tr enc dot1
> >
> > Sw mode tr
> >
> > Channel-group 1 mode on
> >
> >
> >
> >
> >
> > Question: Configure the port channel for UDLD. When unidirectional link is
> > detected, shut down the affected port.
> >
> >
> >
> >
> > Thanking you,
> >
> > Regards
> > Fawaz
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:31 ART