From: toonsh dosh (toonsh@hotmail.com)
Date: Mon Nov 19 2007 - 17:02:25 ART
Hi ,
Sorry for the OT. Was wondering if anyone has had much experience with Polycom
V500 conference units registering as H323 devices on Gatekeeper. I have been
able to get the devices to register fine on GK, I would like these clients to
be able to dial one another directly via the GK. They are currently able to
dial into the MCU no prblem. Should there been anything specific that should
be allowed on the GK to allow the terminals to call one another ? Below find
an excerpt of the config:
gatekeeper zone local zone1d test.com 172.18.2.9 zone local zone1a test.com
zone local zone1b test.com
zone subnet zone1a 172.18.184.130/32 enable zone subnet zone1a
172.18.182.37/32 enable zone subnet zone1a 172.18.181.112/32 enable zone
subnet zone1a 172.18.180.101/32 enable zone subnet zone1a 172.18.184.209/32
enable zone subnet zone1a 172.18.182.157/32 enable
zone prefix zone1a 6712*
zone prefix zone1a 6037*
zone prefix zone1a 6730* zone prefix zone1a 6731*
zone prefix zone1a 6... gw-priority 10 CM_PUB_1 zone prefix zone1a 6...
gw-priority 9 CM_PUB_2
gw-type-prefix 1#* default-technology gw-type-prefix 81* hopoff zone1a gw
ipaddr 172.18.2.10 1720 no use-proxy zone1a default inbound-to terminal no
use-proxy zone1a default outbound-from terminal no use-proxy zone1b default
inbound-to terminal no use-proxy zone1b default outbound-from terminal no
use-proxy zone1c.ibm.com default inbound-to terminal no use-proxy
zone1c.ibm.com default outbound-from terminal no use-proxy zone1d default
inbound-to terminal no use-proxy zone1d default outbound-from terminal no
use-proxy zone1e default inbound-to terminal no use-proxy zone1e default
outbound-from terminal no use-proxy zone1f default inbound-to terminal no
use-proxy zone1f default outbound-from terminal no use-proxy zone1g default
inbound-to terminal no use-proxy zone1g default outbound-from terminal no
use-proxy zone1h default inbound-to terminal no use-proxy zone1h default
outbound-from terminal no shutdown
So for now I would like a device in zone1a which is assigned DN 6712 to call
6037 via the gatekeeper.
Thanks !
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:30 ART