From: Joseph Saad (joseph.samir.saad@gmail.com)
Date: Mon Nov 12 2007 - 13:05:41 ART
Yes, You can.
You'll have to specify an RP manually to them though on each router
pariticipating in Auto-RP. Specially with NBMA-mode.
ip pim rp-address 150.1.2.2 1
access-list 1 permit 224.0.1.39
access-list 1 permit 224.0.1.40
150.1.2.2 would be an IP address reachable and I'd have it enabled
with ip pim sparse-mode "Though I am not sure of that".
Joseph.
On Nov 12, 2007 7:40 PM, Gupta, Gopal (NWCC) <gopal.gupta@hp.com> wrote:
> Hi Folks,
>
> Can we make these 2 groups working in Sparse mode anyway.
> 224.0.1.39 & 224.0.1.40
>
> Suppose R1 is the hub and it has 2 spokes R2 and R3 ; and R2 is RP & MA.
> So R1 wont be able to forward these mapping aganet discovery messages to
> R3. because these 2 groups work in Dense mode and wont be able to cross
> from spoke to spoke.
> one workaround is to configure Tunnel bet R2 and R3 Spokes.
> Is there any way we can make them working in sparse mode and then
> enableing NBMA Mode on R1 without using tunnels.
>
> Regards,
> Gops
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:29 ART