From: Biggs, Jeff \(M/CIO/BIE\) (JBiggs@usaid.gov)
Date: Wed Sep 19 2007 - 11:22:07 ART
sh line 01
Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1 1 AUX 9600/9600 - host - - - 63 0 0/0 -
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 1 stopbits, 8 databits
Status: No Exit Banner, Modem Signals Polled
Capabilities: Modem Callout
Modem state: Idle
Group codes: 0
Modem hardware state: noCTS noDSR noDTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are telnet.
Allowed output transports are lat pad telnet rlogin lapb-ta mop udptn v120 ssh.
Preferred transport is lat.
No output characters are padded
No special data dispatching characters
Jeffrey Biggs
Sr. Network Engineer
M/CIO/BIE
CCNP, CCDA
240-646-5003
jbiggs@usaid.gov
This e-mail is intended for the addressee only. If you are not the intended recipient, please be aware that the unauthorised use or disclosure of the information it contains, or the unauthorised copying or re-transmission of the e-mail are strictly prohibited. Such action may result in legal proceedings. If the e-mail has been sent to you in error, please accept our apologies, advise the sender as soon as possible and then delete the message. Under the Freedom of Information Act 2000 / Data Protection Act 1998, the contents of this e-mail, whether it is marked confidential or otherwise, may be disclosed.
-----Original Message-----
From: Sadiq Yakasai [mailto:sadiqtanko@gmail.com]
Sent: Wednesday, September 19, 2007 10:21 AM
To: Biggs, Jeff (M/CIO/BIE)
Cc: Gregory Gombas; ccielab@groupstudy.com
Subject: Re: Reverse Telnet issue
How about a show line xx, for the aux line?
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:13 ART