From: Andy Mrozek (hansolo@yahoo.com)
Date: Sat Sep 15 2007 - 14:44:38 ART
Yea I get the same thing I looked up the sysystem message in the configs
guides and its explanation is weak. It's not related to mode either as I
tried it in both trans/server modes..
Error Message PM-2-VLAN_ADD: Failed to add VLAN [dec] - [chars].
--------------------------------------------------------------------------------
Note This message applies to Catalyst 3750, 3560, 3550, 2970, and 2960
switches.
--------------------------------------------------------------------------------
Explanation The software failed to add the VLAN to the VLAN Trunking
Protocol (VTP) database. [dec] is the VLAN ID, and [chars] specifies the
reason for the failure.
Switch(config-if)#switchport voice vlan dot1p
% Voice VLAN does not exist. Creating vlan 0
Switch(config-if)#
00:21:20: %PM-2-VLAN_ADD: Failed to add VLAN 0 - VLAN not found.
On Sat, 15 Sep 2007, Jay Hanke wrote:
> I'm trying to get the following working on a 3560 (C3560 Software
> (C3560-ADVIPSERVICESK9-M), Version 12.2(25)SEE2)
>
>
>
> The task at hand is getting a phone that is sending 802.1p marked voice
> packets working (rather than a separate voice vlan)
>
>
>
> Interface fa0/15
>
> Switchport voice vlan dot1p
>
>
>
> The command takes but I get an error back a couple of seconds later
> about being unable to create vlan 0.
>
>
>
> 00:01:11: %PM-2-VLAN_ADD: Failed to add VLAN 0 - VLAN not found.
>
>
>
> Thanks,
>
>
>
> Jay
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:12 ART