From: Joseph Brunner (joe@affirmedsystems.com)
Date: Mon Sep 10 2007 - 22:45:53 ART
Forget discussing the real lab here. There is an NDA so I wont comment on
the real lab.
In the IE workbooks however, sometimes you are FORBIDDEN from using
"ip ospf network point-to-point" on the loopbacks or it just says
"do not use the "ip ospf network" command to complete this task"
Your cue then should be
Route-map CONN->OSPF permit 10
Match int loop0
Router ospf 1
Redistribute connected subnets route-map CONN->OSPF
The redistributed E2/E1 route will have the shorter mask.
-Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tandou Mohamed
Sent: Monday, September 10, 2007 9:30 PM
To: ccielab@groupstudy.com
Subject: IP OSPF NETWORK POINT-TO-POINT
GS,
During the lab real or vendor labs when the question ask to advertise
loopback interface into OSPF domain. should i configure ip ospf network
point-to-point under the loopback or just leave it alone till the question
say to do so. Please advise.
TM
---------------------------------
Got a little couch potato?
Check out fun summer activities for kids.
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:10 ART