From: Tony Blanco (blancoj17@yahoo.com)
Date: Thu Aug 30 2007 - 16:04:49 ART
Team,
I am about to use the Dynamips emulation and it looks great until I starting configuring the switchs....so far the following are the problems that I am having:
1 - When I go to config t and try to create my vlans...(there is not options for creating vlans here), the only way to create my vlans is going to vlan database and then be able to create the vlans.
2 - I can not change the vtp domain, type..... from the config t.....
3 - After i create my vlans via the old way (vlan database) I do not see my vlans after I exit the vlan database mode.....
FYI I downloaded the configuration's recomendation from Internetworkexpert site in order to use their's demo lab......
FYI...I already have my own hardware lab at home but I am thinking to use Dynamips at office or any where else so I do not have to remotely logon to my lab at home.....See below what I mean....
Rack1SW1#config t
Enter configuration commands, one per line. End with CNTL/Z.
Rack1SW1(config)#vlan ?
accounting VLAN accounting configuration
Rack1SW1(config)#vlan
% Incomplete command.
Rack1SW1(config)#
Rack1SW1(config)#
Rack1SW1(config)#vtp mode ?
% Unrecognized command
Rack1SW1(config)#vtp ?
file Configure IFS filesystem file where VTP configuration is stored.
if-id Configure interface as the preferred source for the VTP IP updater
address.
Rack1SW1(config)#vtp
% Incomplete command.
Rack1SW1(config)#
Rack1SW1(config)#
Do I am missing anything here....what is going on....
Thanks for your help.....(I hope there is fix for this)....
Juan
____________________________________________________________________________________
Park yourself in front of a world of choices in alternative vehicles. Visit the Yahoo! Auto Green Center.
http://autos.yahoo.com/green_center/
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:13 ART