From: Gadad, Milind (m-gadad1@ti.com)
Date: Fri Aug 10 2007 - 11:12:24 ART
The below configuration works.
Regards,
Milind
________________________________
From: tom sun [mailto:tomsun2007@gmail.com]
Sent: Thursday, August 09, 2007 11:01 PM
To: Antonio Soares
Cc: Gadad, Milind; ccielab@groupstudy.com
Subject: Re: MFR interface - frame-relay encapsulation
i think ,if 2 routers use back-to-back mode to connect themselves .it
does not support frame-relay encapsulation ,maybe you can select hdlc or
ppp !!!
On 8/9/07, Antonio Soares <amsoares@netcabo.pt> wrote:
I have here a working config. I used dynamips:
+++++++++++++++++++++++++++++
R1:
!
interface MFR12
no ip address
frame-relay intf-type dce
!
interface MFR12.1 point-to-point
ip address 12.12.12.1 255.255.255.0
frame-relay interface-dlci 102
!
interface Serial1/0
no ip address
encapsulation frame-relay MFR12
serial restart-delay 0
no arp frame-relay
!
interface Serial1/1
no ip address
encapsulation frame-relay MFR12
serial restart-delay 0
no arp frame-relay
!
+++++++++++++++++++++++++++++
R2:
!
interface MFR12
no ip address
!
interface MFR12.1 point-to-point
ip address 12.12.12.2 255.255.255.0
frame-relay interface-dlci 102
!
interface Serial1/0
no ip address
encapsulation frame-relay MFR12
serial restart-delay 0
no arp frame-relay
!
interface Serial1/1
no ip address
encapsulation frame-relay MFR12
serial restart-delay 0
no arp frame-relay
!
+++++++++++++++++++++++++++++
R1#
R1#ping 12.12.12.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.12.12.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 92/122/192
ms
R1#
+++++++++++++++++++++++++++++
R1#sh frame multi
Bundle: MFR12, State = up, class = A, fragmentation disabled
BID = MFR12
Bundle links:
Serial1/1, HW state = up, link state = Up, LID = Serial1/1
Serial1/0, HW state = up, link state = Up, LID = Serial1/0
R1#
+++++++++++++++++++++++++++++
Regards,
Antonio Soares
CCIE #18473, CCNP, CCIP
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Gadad, Milind
Sent: quinta-feira, 9 de Agosto de 2007 18:05
To: ccielab@groupstudy.com
Subject: MFR interface - frame-relay encapsulation
Can we connect 2 routers back to back with frame-relay encapsulation? I
don't have a frame-rely switch in between the two routers.
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:10 ART