BGP aggregate addresses

From: Patrick Galligan (pgalligan@gmail.com)
Date: Fri Aug 10 2007 - 00:57:33 ART

• Next message: tom sun: "Re: MFR interface - frame-relay encapsulation"
• Previous message: tom sun: "Re: OSPF Summarization question"
• Next in thread: Bit Gossip: "Re: BGP aggregate addresses"
• Maybe reply: Bit Gossip: "Re: BGP aggregate addresses"
• Maybe reply: Bhaskar Sivanesan: "Re: BGP aggregate addresses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi group,

My understanding of BGP aggregate addresses is that it will advertise
the aggregate if there is at least one network within the aggregate in
the BGP table. However, I have the following problem:

I am aggregating 10.64.192.0/19 from an iBGP peer which is a route
reflector client. It has loopbacks within this range, eg
10.64.200.1/24, but the aggregate only gets advertised if
10.64.192.0/24 is in the BGP table. Is this normal behaviour?

Thanks,
Patrick

-- 
You can't cheat death forever, but you can make the b!stard work for it.

• Next message: tom sun: "Re: MFR interface - frame-relay encapsulation"
• Previous message: tom sun: "Re: OSPF Summarization question"
• Next in thread: Bit Gossip: "Re: BGP aggregate addresses"
• Maybe reply: Bit Gossip: "Re: BGP aggregate addresses"
• Maybe reply: Bhaskar Sivanesan: "Re: BGP aggregate addresses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:10 ART