From: Serhat Aslan (serhatworks@gmail.com)
Date: Tue Aug 07 2007 - 13:17:00 ART
Did you check the unicast reachability of rp/agent to clients and pim
enable interfaces ? if you did can you send the config ?
Serhat Aslan
On 8/7/07, ISolveSystems <support@isolvesystems.com> wrote:
>
> I have tried the nbmp mode with same result.
>
> I have the broadcase keyword...
> frame-relay map ip 174.1.145.4 104 broadcast
> frame-relay map ip 174.1.145.5 105 broadcast
>
>
> On 8/7/07, Salau, Yemi <yemi.salau@siemens.com> wrote:
> >
> > 1. tried ip pim nbma-mode on R1's serial interface?
> > 2. Sure the FR interfaces/dlcis are broadcast compatible? ie.
> > Frame-relay map with broadcast keyword?
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> > ISolveSystems
> > Sent: Tuesday, August 07, 2007 3:43 PM
> > To: Group study
> > Subject: RP mapping info not received
> >
> > Hello Expert,
> > R1, R4, R5 are full meshed FR. R1 is the RP. R3 is the mapping agent.
> > All connected interfaces are configured with pim sparse dense mode and
> > are
> > all neighbor up.
> >
> > For some reason R4 and R5 are not receiving rp mapping from R3. Any
> > idea?
> >
> > R4
> > \
> > \
> > R1-----R3----R2
> > /
> > /
> > R5
> >
> > Thanks.
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:09 ART