From: Ajay Prakash (ajay.prakash@networkpeople.co.in)
Date: Thu Jul 26 2007 - 01:08:47 ART
hmmm.. I dont know but the problem resolved itself after a reload of the 4
routers...
Ajay
----- Original Message -----
From: Ajay Prakash
To: Cisco certification
Sent: Thursday, July 26, 2007 9:22 AM
Subject: Problem with Frame relay Inverse Arp
Hello,
I am trying to configure a frame relay full mesh with 4 routers
R2
R1 Frame Relay R3
R4
The task asks me not to use static mappings. So all i needed to do was to
enable frame relay encapsulation and inverse arp should have taken care of the
rest. However when i check the frame relay mappings, R2 has a map to all 3
other routers which is good. The routers R1, R3 and R4 only have mappings to
R2. The other dynamic mappings are missing.
I have waited for quie some time and the dynamic mappings have not appeared.
I have tried static mappings and they work fine telling me that the frame
relay pvc is alright.
Any suggestions??
Regards,
Ajay Prakash
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:42 ART